Messages

 Thank you for your response. I now live in Central Texas I moved here from Northern Illinois. If you have pictures of the repair can you please post them. I am curious to see the solution.My travel trailer was built in February 2017 but the Vin number is right in the middle of the recall list. My drawbar goes all the way to the front axle.  My frame and A-frame are the same size there are no steps.  I am very pleased to hear your travel trailer is doing very well gives me something to look forward to thank you. Mr Smith

 Has anybody taken their travel trailers in for the recall yet if so when and where. thank you. Mr Smith

 Thank you for the replies I will try them, After I get the recall fixed on the drawbar cracks. Keep the solutions coming. Thank you Mr Smith

 Does anybody have the same problem as I do. I have a 2017 21 RBS.  Every time I drive in the rain the floor of my travel trailer is flooded  really bad. I have tried 4"  eterna bond tape,  and spray sealer. Nothing seems to work. Any help would be appreciated. Thank you Mr Smith
PS yes the water is coming from the wheel wells I followed the dirt trails back to them.

 How do I go about replacing my fender. My fender cracked from extreme cold presumably, nothing hit it just cracked and broken in four places. Is this covered under the two-year warranty.  Only the one on the  door side cracked. The one underneath the slide is fine. Has anybody else experienced this on any type of travel trailer or fifth wheel.  Can use some help. Thank you Mr Smith

Let us know if works out.  Be careful not to go all the way through the floor because you'll rip the seals out from underneath when the slide goes in and out. Best of luck. Mr Smith

When I move to Texas sometime in the spring of 2018 I plan on trading my camp lite 21 RBS in on a Lance travel trailer 1985.  Don't tell anybody but I should've listened to the wife and got the Lance 1985.
Mr Smith

 Not just the bottom of the slide, the whole floor in the camper is Styrofoam. That means all your cabinets are screwed down the same way, right in the Styrofoam if there's no aluminum backing for the screws to go into all the screws are just going to be pulled out  overtime. I'm very disappointed in camp late, Thor actually. 
Mr Smith

 This is exactly what I was afraid of with the new Styrofoam floor. I've noticed a few of the screws pulled out from underneath holding up the wiring harness and there's no way to screw them back into Styrofoam.  Now I'm worried about mine if the screws don't go through the floor and hit the frame the screws are just going to pull out of the Styrofoam floor. Between the Styrofoam floor and the TPO roof that you can't walk on to clean, and maintain is very sad. How disappointing, I am starting to regret my purchase decision. Mr Smith

 You need the 2 x 4 on the frame. And if you put a jackstand in the wrong place on the torsion tube you can damage the tube and then the suspension would wear out prematurely.  Just saying that leaf spring suspension is much easier to work with. The tire that needs to be replace is the only one that gets jacked up not the whole side of the trailer to me that's a little on the sketchy side when trying to change a tire on the side of the road, and you have half the trailer Jack up at one single point that is not very stable.

 This is why I like the new axle set up. A simple bottle jack and jackstand is all you need to change the tire, no special jacking sequences needed, like with torsion bar suspension. Just put the bottle jack underneath the U-bolt plate and off you go. Oh by the way when we took the trailer to Wisconsin Dells it Road very smooth.
Mr Smith

I have a 2017 cl 21RBS  with aluminum cabinets and dinette. Build date 02.2017. And it has this.

 Thank you  tbrady for the information about the fitting. I just installed it yesterday and it is working beautifully. Again thank you a lot more usable water.  All I had to do was remove the front tire and the drill fit perfectly did not have to drop the tank at all.  Thank you thank you thank you.
Mr Smith

 I have a 2017, 21 RBS. And I can't hear you over my AC unit on mine. LOL 
Mr Smith

 Thank you very much for the replies. I traced it down to a defective 50 amp fuse mounted to the frame, one of the studs was pulled out for some reason I don't know why.  So I replaced it and all is well. Thank you very much for all the help from everybody. Mr Smith